Free NSE7_SDW-7.0 Exam Braindumps

Pass your Fortinet NSE 7 - SD-WAN 7.0 exam with these free Questions and Answers

Page 2 of 7
QUESTION 1

In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

  1. A. Traffic has matched none of the FortiGate policy routes.
  2. B. Matched traffic failed RPF and was caught by the rule.
  3. C. The FIB lookup resolved interface was the SD-WAN interface.
  4. D. An absolute SD-WAN rule was defined and matched traffic.

Correct Answer: AC

QUESTION 2

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The administrator configured ADVPN on both hub-and-spoke groups.
NSE7_SDW-7.0 dumps exhibit
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)

  1. A. London generates an IKE information message that contains the Toronto public IP address.
  2. B. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN.
  3. C. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
  4. D. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.

Correct Answer: BD

QUESTION 3

Which two statements about SD-WAN central management are true? (Choose two.)

  1. A. The objects are saved in the ADOM common object database.
  2. B. It does not support meta fields.
  3. C. It uses templates to configure SD-WAN on managed devices.
  4. D. It supports normalized interfaces for SD-WAN member configuration.

Correct Answer: AC
Normalized interfaces are not supported for SD-WAN templates. You can create multiple SD-WAN zones and add interface members to the SD-WAN zones. You must bind the interface members by name to physical interfaces or VPN
interfaces.https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-new-features/794804/new-sd-wan-template

QUESTION 4

Refer to the exhibit.
NSE7_SDW-7.0 dumps exhibit
Which algorithm does SD-WAN use to distribute traffic that does not match any of the SD-WAN rules?

  1. A. All traffic from a source IP to a destination IP is sent to the same interface.
  2. B. All traffic from a source IP is sent to the same interface.
  3. C. All traffic from a source IP is sent to the most used interface.
  4. D. All traffic from a source IP to a destination IP is sent to the least used interface.

Correct Answer: A

QUESTION 5

Refer to the exhibit.
NSE7_SDW-7.0 dumps exhibit
An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)

  1. A. The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.
  2. B. T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.
  3. C. T_INET_0_0 does not have a valid route to the destination.
  4. D. T_INET_1_0 has a higher member configuration priority than T_INET_0_0.

Correct Answer: AC

Page 2 of 7

Post your Comments and Discuss Fortinet NSE7_SDW-7.0 exam with other Community members: