Free N10-008 Exam Braindumps

- (Exam Topic 3)
A network administrator is testing performance improvements by configuring channel bonding on an 802.Hac AP. Although a site survey detected the majority of the 5GHz frequency spectrum was idle, being used only by the company's WLAN and a nearby government radio system, the AP is not allowing the administrator to manually configure a large portion of the 5GHz frequency range. Which of the following would be BEST to configure for the WLAN being tested?

1. A. Upgrade the equipment to an AP that supports manual configuration of the ElRP power settings.
2. B. Switch to 802.11
3. C. disable channel auto-selection, and enforce channel bonding on the configuration.
4. D. Set up the AP to perform a dynamic selection of the frequency according to regulatory requirements.
5. E. Deactivate the band 5GHz to avoid Interference with the government radio

Correct Answer: C

- (Exam Topic 3)
A company joins a bank's financial network and establishes a connection to the clearinghouse servers in the range 192 168.124.0/27. An IT technician then realizes the range exists within the VM pool at the data center. Which of the following is the BEST way for the technician to connect to the bank's servers?

1. A. NAT
2. B. PAT
3. C. CIDR
4. D. SLAAC

Correct Answer: A

- (Exam Topic 3)
A network engineer is monitoring a fiber uplink to a remote office and notes the uplink has been operating at 100

1. A. Latency
2. B. Jitter
3. C. Speed
4. D. Bandwidth

Correct Answer: A
When a fiber uplink is operating at 100

- (Exam Topic 3)
A network technician reviews an entry on the syslog server and discovers the following message from a switch:
SPANNING-TREE Port 1/1 BLOCKED
Which of the following describes the issue?

1. A. A loop was discovered, and the impact was mitigated.
2. B. An incorrectly pinned cable was disconnected.
3. C. The link-local address on the port is incorrect.
4. D. The port was shut down, and it needs to be reactivated.

Correct Answer: A

- (Exam Topic 3)
A network administrator is investigating a network event that is causing all communication to stop. The network administrator is unable to use SSH to connect to the switch but is able to gain access using the serial console port. While monitoring port statistics, the administrator sees the following:

Which of the following is MOST likely causing the network outage?

1. A. Duplicate IP address
2. B. High collisions
3. C. Asynchronous route
4. D. Switch loop

Correct Answer: B